How to Test a Used iPad Before Buying

Buying from eBay, Swappa, Back Market or Facebook Marketplace? Work through this checklist with the iPad in your hands before you pay. The first two steps catch the locks that make an iPad worthless, and ex-school iPads are everywhere on the used market. The rest runs free in your browser, in about fifteen minutes total.

  1. Check Find My iPad is switched off

    Open Settings, tap the name at the top, then Find My. Find My iPad must be OFF and the iPad signed out of the seller’s Apple Account. An iPad still linked to their account is activation-locked and unusable to anyone else. No reset or repair shop can remove it. If the seller cannot sign out on the spot, walk away.

    Checked on the iPad itself, no tool needed.

  2. Rule out school or company management (MDM)

    Many used iPads come from schools and businesses. Look in Settings, General, VPN & Device Management for a management profile, and ideally have the seller erase the iPad in front of you: if a Remote Management screen appears during setup, the iPad belongs to an organisation and will keep re-locking. Walk away unless the organisation has released it.

    Checked on the iPad itself, no tool needed.

  3. Confirm the model and storage match the listing

    Settings, General, About shows the model name, model number, capacity and, on cellular models, the IMEI. Check the model number against Apple’s identification list, because older generations are often listed as newer ones. On cellular iPads, run the IMEI through a free checker for lost, stolen or blacklisted status.

    Checked on the iPad itself, no tool needed.

  4. Check the battery health

    On recent models, Settings, Battery, Battery Health shows Maximum Capacity and the cycle count; 85% or higher is healthy. Many older iPads do not show this screen at all; then a Mac app such as coconutBattery can read the battery over a cable, or watch how fast the charge drops during your ten minutes of testing.

    Checked on the iPad itself, no tool needed.

  5. Inspect the screen for dead pixels and pressure marks

    Fill the screen with solid colours to catch dead or stuck pixels, bright spots and pressure marks. Large iPad panels pick up pressure damage from being carried in bags, and it shows best on white and grey.

    Open the dead pixel test →
  6. Test the whole touchscreen

    Drag across every part of the display, including the corners, to find dead zones. Third-party screen replacements on iPads often leave an unresponsive strip along one edge.

    Open the touchscreen test →
  7. Test multi-touch

    Put several fingers down at once. Failed multi-touch breaks pinch-to-zoom, multitasking gestures and typing on the on-screen keyboard.

    Open the touchscreen test →
  8. Test the Apple Pencil, if included

    Check the Pencil generation actually works with this iPad on Apple’s compatibility page, because the generations are not interchangeable. Pair it, open Notes and draw: light strokes should be thin, firm strokes thick, and tilting should shade. Draw slowly along every edge of the screen to catch gaps in the digitiser.

    Checked on the iPad itself, no tool needed.

  9. Test the cameras

    Check the front camera here, then open the Camera app for the rear lens. Look for dust behind the glass, a lens that will not focus and, on models with Center Stage, that framing follows you.

    Open the camera test →
  10. Test the speakers and microphones

    Play the left and right test tones and cover each speaker grille in turn. On four-speaker models a single dead speaker is easy to miss. Then record a voice memo to check the microphones.

    Open the audio test →
  11. Check rotation and motion sensors

    Rotate the iPad and confirm the screen and sensor readings follow. A stuck orientation usually means a failed sensor or a hard drop.

    Open the accelerometer test →
  12. Check the body is flat and the port charges

    Lay the iPad screen-down on a flat table and press each corner: a bent chassis rocks, and thin iPad Pro and Air models bend more easily than they look. Plug in a charger and wiggle the cable gently. Charging should not cut in and out.

    Checked on the iPad itself, no tool needed.

Red flags: negotiate hard or walk away

  • The seller cannot or will not sign out of their Apple Account. Walk away. This is not negotiable.
  • A Remote Management screen during setup, or a management profile the seller cannot remove.
  • The model number belongs to an older generation than the listing claims.
  • The IMEI on a cellular model comes back lost, stolen or blacklisted.
  • Dead touch zones, or Pencil strokes that skip near the edges.
  • A chassis that rocks on a flat table.
  • The seller will not let you spend fifteen minutes with it before paying.

Frequently Asked Questions

What should I check first when buying a used iPad?

Activation Lock and device management. A Find My lock under the seller’s Apple Account, or school or company enrolment, makes the iPad unusable to you. Check both before anything else.

How do I check the battery health of a used iPad?

On recent models, Settings → Battery → Battery Health shows Maximum Capacity and cycle count; aim for 85% or higher. Many older iPads lack this screen. Use a Mac app such as coconutBattery, or watch the charge drop while you test.

How can I tell if a used iPad is from a school or company?

A profile under Settings → General → VPN & Device Management, or a Remote Management screen during setup after an erase. Bypassed enrolment can come back, so only buy if the organisation has released it.

Will my Apple Pencil work with a used iPad?

Only if the generations match. Check Apple’s compatibility page for the exact model number, then test pressure and tilt in Notes before paying.

How long does the full check take?

About fifteen minutes. The lock checks take a couple of minutes and should never be skipped.